Blog Postings

Pat Blog Thumb_Imec

Imec Develops Method for Co-Integration of GaN Half-Bridge With Drivers to Boost Performance

At PCIM 2019 last month, imec announced a functional GaN half-bridge monolithically integrated with drivers. The release described how mounted on a buck-convertor test board, the chip converts an input voltage of 48 V to an output voltage of 1 V, with a pulse width modulation signal of 1 MHz. The achievement leverages on imec’s GaN-on-SOI and GaN-on-QST® technology platforms, reducing parasitic inductance and boosting commutation speed.


Read More
FGM_EB_Thumb

Test Your TDR with a DMM

A TDR (time domain reflectometer) is an instrument that probably has the fastest rise time of any instrument in your lab, but how accurate is it? Eric tests accuracy using a DC Ohmmeter in this piece.


Read More
thumb 6.11 feature_

Coming Up: Easier Signal Integrity Simulation Setup with IBIS 7.0

There was a time when the signal integrity of connections between digital ICs could be nearly ensured by following one simple rule: don’t connect more than some maximum number of input pins to any single output pin. Often the fanout limit would be around 7. No models, no simulations. Everything we needed was in the thick books of vendor datasheets that filled our shelves, the tree-killing viral precursor to AOL installation CDs. Ah, those were the days!


Read More
The Evolutionary Path to the 100 Amp Micromodule Regulator_thumb

The Evolutionary Path to the 100 Amp Micromodule Regulator

A micromodule device resembles a surface mount IC; however, they include all the necessary support components that would normally be used to construct a power conversion circuit. This includes a DC/DC controller, MOSFET dice, magnetics, capacitors and resistors and so on, all mounted on a thermally efficient laminate substrate. They are then encapsulated using a plastic mold cap. The result was a complete power supply that can be simply adhered to a printed circuit board. Read about the evolution of this device.


Read More
thumb

Just how good are VNA Measurements?

Just because someone has a VNA capable of 60 GHz bandwidth doesn’t mean it will always give the same results. It is not the instrument, but the measurement procedure that seems to influence the quality of the measurements the most.  Read on for information on a recent study from Jason Ellison, Heidi Barnes, and Jose Moreira  as well as 7 tips for improving your measurements.


Read More
thumb_2

The Future of Power Integrity

Get six experts in a room together and you are likely to hear seven different opinions. Not so at the Future of Power Integrity Panel Discussion at DesignCon 2019.  The consensus of this panel of experts is that the future of power integrity will include single processor chips drawing as much as 1000 A and more. Read on for the details of this discussion!


Read More