Power Integrity

thumb

Bode Plots are Overrated

I’m not saying control loop stability isn’t important, of course it is. I am saying that whether your focus is power supply design, power integrity or mixed-signal, the Bode plot probably isn’t going to provide you with a reliable or optimum solution. Here are five major reasons for saying this...
Read More
TA_Designing Power for Sensitive Circuits

Designing Power for Sensitive Circuits

How do you design power for sensitive circuits including LNAs, clocks, and PLL circuits? Although these circuits consume low power, they are sensitive to even very low levels of power rail noise. This EDI CON USA 2017 Outstanind Paper Award wining paper discusses the various noise paths that contribute to the degradation of the sensitive circuit as well as how to optimize, measure, and troubleshoot power supply related noise for these applications.


Read More
Flapping Switch

Current Sharing Measurements in Multi-Phase Switch Mode DC-DC Converters

This paper, presented at EDI CON USA 2017, demonstrates the use of a special probe tip utilized to convert a differential measurement of inductor voltage to a measurement of inductor current. It shows the connection and calibration considerations in the measurement of inductor current, including the digital signal processing algorithms required to compensate for the components in the power supply and the probe tip. It also explains current sharing measurements made in the time and frequency domain using a transient current generator.


Read More
IMG_6826 650x400

Measuring Sub-milliOhm PDN Impedance

Measuring sub-milliOhms is difficult.  Getting low noise, sub-milliOhm measurements in very small circuits is a bit more difficult.  We recently had the opportunity to support R&D Altanova in performing this difficult measurement, here are some of the results.


Read More