Items Tagged with 'power rail'

In this article, power rail voltage measurement uncertainty is examined using several different probe configurations to monitor VCore measurements on a Picotest S2000 load stepper board. The results reveal measurement variations up to 27 mV — a level of uncertainty that can completely mask the performance improvements engineers are seeking from advanced VRM technologies. Read on to learn how engineers can trust their measurements when the uncertainty exceeds the performance gains they are trying to validate.

This paper comprehensively addresses the numerous challenges presented when designing a power distribution network for a scalable 2000 Amp power supply and provides a complete process for designing, simulating, and validating a 2000 Amp core power rail. 

Do I really need to use a power rail probe to measure ripple and noise? Power rail probes are single ended, so does that mean I can only monitor one power rail at a time? Are there other, more affordable options available? In this blog post, Steve Sandler answers to these questions and more.

Probing signals with a bandwidth below 100 MHz and voltage sensitivity above 100 mV is a no-brainer. Regardless of the type of signal or the source impedance, the venerable 10x passive probe is the answer. However, at bandwidths >100 MHz and with voltage sensitivity <100 mV, the 10x passive probe may not be the best option. In this article, SIJ technical editor Eric Bogatin introduces an easy-to-implement, low-cost alternative to the 10x passive probe specifically for power-rail measurements.

The goal of power integrity (PI) analysis is to ensure not only sufficient but also stable power to all chips in a system. This article uses the example of a DDR4 application to explain the choices surrounding the use of decoupling capacitors to reduce impedance, and which performance parameters are critical to success.

In exploring options to demonstrate ringing from reflections in transmission lines, Professor Eric Bogatin gets a greater understanding of debouncing circuits. Read on to see where his investigations led him.